Hollow Log House

click to enlarge

log house exterior
log house interior

About 2 1/2 feet high, the log was carved out of cedar by a chainsaw sculptor. The moss-covered roof is a partially hollowed cone-shaped piece of the log which he then cut off, so he could hollow the log. The bottom floor is also a separate piece of the cedar cut from the other end. The windows are shuttered with twig shutters, and have twig dividers.

The "floating" steps leading up to a little loft are little coin-shaped pieces I cut from a branch, then drilled a small hole about 1/4" deep into each edge, glued in a piece of toothpick, and glued the other end of the toothpick into a corresponding hole in the wall of the log.

There is a small fishing pond to the right of the entry (left picture). You can see a twig bench swing hanging from some ivy in the right picture on the right side, and in the left picture on the left.

The whole structure is on a lazy Susan, mounted to a round piece of wood about 24" in diameter. The landscape base was created with spray sealing foam - a wonderful product and easy to use. As it cures, it eventually expands by about 40%. After it hardens it is like a light-weight Styrofoam, and very easy to carve and stick things into.

The overhang is shingled with pine cone petals, with bits of moss here and there. Those are acorn buttons at the corners. The "stepping stones" are wooden rounds, like the stairs inside.

 

Click on picture below
to see it furnished as "Fairy Hollow" for the
September 1997 Seattle Dollhouse and Miniature Show

Link to Fairy Hollow

Mossy Manor | Victorian Dollhouse | New House | Home | Email